CM Promax SC-800, Руководство по эксплуатации

Страница: 10 / 44

8
3.4 OPERATION OF THE PNC-01 DIGITAL CONTROL
PANEL
3.4.1 Operation of the Model PNC-01 Digital Control Panel
When following the instructions for programming your machine please refer
to Fig.5 below.
Figure 5
PRO G RA M
PROGRAM TIME / %
SK IP
CY CLE
STO P
CY CLE
STB
W O RK V A C
G A S
SEA L1 SEA L2 CO O L SO FT G A S
SH IFT
G A S
O N /O FF
PU LSE
O N /O FF
O IL CH G
A IR O N /O FF
PU LSE
PU RG E PO W ER O N PO W ER O FF
Standard Machine – Basic Instructions
A . Press the Main Power switch located to the right of the control panel.
1. The Main Power switch will NOT light up.
2. The standby, STB, LED on the control panel will light up.
B . Press the Power ON touch pad on the control panel.
1. The Program display and the Time/% display will light up.
2. The Program display will indicate what program the machine is running.
3. The Time/% display will indicate the vacuum setting for that program.
C. Changing to a different program
1. Press either the Up or the Down arrow key on the control panel.
2. You will see the number displayed in the Program display change.
3. Select the program number before the one you want to move to
4. Press the
Up arrow key and hold it down for approximately 5 seconds.
5. You will see the number in the Program Display begin to blink.
6. Press the Up arrow key once and it will stop blinking.
7. Using the Up / Down arrows go back to the program number you chose.
8. Important: Cycle the machine 1 time to save program change.