Club Car Tempo Walk, Руководство пользователя

Страница: 11 / 43

10
USB Charge Port for Cell Phone Charging
The 5
–volt 2.4-amp outlet (Figure 9) provides electricity to power and recharge portable devices. The
USB port is not designed for the transfer of data.
Figure 9 USB Port
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Club Car unit has been thoroughly inspected and adjusted at the factory; however, upon receiving
your new unit(s), you should become familiar with its controls, indicators, and operation. Carefully inspect
each unit to ensure that it is in proper working condition before accepting delivery.
Use the following checklist as a guide to inspect the unit. This checklist should be used daily to ensure
that the unit is in proper working condition and in conjunction with the Performance Inspection on
page
11, and the Periodic Service Schedules on page 19. Any problems should be corrected by a Club Car
distributor/dealer or a trained technician.
Any unit not functioning correctly should be removed from use until it is properly repaired. This
will prevent further damage to the unit and avoid the possibility of injury due to unsafe conditions.
● General: All the parts should be in place and properly installed. Be sure that all nuts, bolts, and
screws are tight.
● Safety and information decals: Check to ensure that all safety and information decals are in
place. See Safety Decal and Feature Identification on page 5.
● Tires: Visually inspect tires for wear, damage, and proper inflation on a daily basis. See unit
Tempo Walk Specifications on page 32.
● Charger cord, plug, and receptacle: Visually inspect for cracks, loose connections, and frayed
wiring. See Plug and Receptacle on page 27.
PERFORMANCE INSPECTION
After you have familiarized yourself with the
Tempo Walk’s controls, have read and understood the
operating instructions, and have watched the tutorial video, then take the unit out for a test walk.
Use the following checklist in conjunction with the Daily Pre-Operation and Safety Checklist as a guide to
inspect the unit and check daily for proper operation. Any problems should be corrected by a Club Car
distributor/dealer or a trained technician.
● Brakes: Be sure to check that both rear motor brakes function properly. When the unit is turned
off, the brakes should hold Tempo Walk firmly in place on both sides of the unit. If the unit is
powered on, and is in the “Run” position, both brakes should also hold the unit firmly in place. If
the unit is placed in the “neutral” position, it should roll freely by hand. If the unit fails to exhibit
these conditions have the motor brakes checked and adjusted as required.