Club Car IntelliTach Carryall 295, Руководство пользователя

Страница: 51 / 72

Engine Oil
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual Page 49
6. Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compres-
sion washer remains on the drain plug. Inspect the compression washer and replace if necessary.
7. Use a socket or wrench to replace the oil drain plug. Turn the plug clockwise and tighten to 31 ft-lb (42
N·m) for diesel vehicles.
Engine Oil Filter Change
1. Drain the engine oil. See Engine Oil Draining on page 48.
2. Place the oil drain pan under the engine oil filter (2) (Figure 52) .
3. Remove the engine oil filter. Turn it counterclockwise and drain the residual oil in the filter port and filter
into the oil drain pan. See following NOTE.
NOTE: An oil drip guard can be used to prevent excess oil from dripping onto the engine base plate. Use
an empty quart (one liter) container and cut the bottom off at an angle, then slide the open area of
the container up and under the oil filter before removal. Position the port of the plastic container so
oil will be directed into the oil pan (Figure 52). A drip guard can be made by folding a piece of card-
board, thin metal, or plastic under the oil filter, forming a channel to direct the filter port oil into the
drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
4. Use a clean, lint-free rag to wipe the oil filter port flange surface clean where the oil filter gasket seats.
5. To help seal the new oil filter to the oil port flange, apply a light coat of white lithium NLGI Number 2
grease (Dow Corning
®
BR2-Plus or equivalent) or new engine oil to the rubber seal around the outside
surface of the filter before attaching it to the oil filter port (Figure 53) . Install the new oil filter (diesel: CCI/
PN 102703301) onto the engine oil filter port. See following NOTE.
NOTE: Use only Club Car oil filters designed for your engine.
6. Tighten the oil filter by hand 2/3 turn after gasket contact. Do not use a band wrench or channel lock pliers.
Figure 51 Engine Oil Drain Plug and Oil Filter – Diesel
Vehicles
Figure 52 Remove Engine Oil Filter
1
2
VIEW FROM UNDERSIDE OF VEHICLE
USED OIL FILTER
OIL DRIP GUARD
DRAIN PAN