Club Car IntelliTach Carryall 295, Руководство пользователя

Страница: 35 / 72

Attachments and Buckets
2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual Page 33
Backfilling
1. Lower the attachment arm (A) (Figure 30) and put the cutting edge of the bucket on the ground (D).
2. Drive forward to the edge of the hole to push the material into the hole.
3. Tilt the bucket forward (D) (Figure 30) as soon as it is past the edge of the hole.
4. If necessary, raise the attachment arm to empty the bucket.
REMOVING AND INSTALLING THE ATTACHMENT ARM MECHANISM
When the attachment arm mechanism is not being used, it can be removed from the vehicle.
NOTE: Remove the bucket or the attachment before attempting to remove the attachment arm mecha-
nism from the vehicle.
Removing the Attachment Arm
NOTE: When removing the cylinders from the attachment arm or the interface, the cylinders may need to
be retracted slightly. Do not have hands in the area of the cylinders when extending or retracting
the cylinders.
1. Lower the attachment arm to the ground and tilt the attachment interface forward (Figure 31) .
2. Stop the engine, put the Forward/Reverse Handle in NEUTRAL, engage the park brake, unfasten your
seat belt, and exit the vehicle.
3. Remove the retaining ring (1) and pin (2) from the attachment interface cylinder rod end, and keep the
retaining ring and pin for later use in this procedure (Figure 32) .
Figure 30 Joystick Position – Backfilling
Figure 31 Lower Arm and Tilt Interface Forward Figure 32 Remove Interface Cylinder Retaining Pin
A
B
C
D