background image

Installation Steps

PLEASE NOTE

: A 3/32 in. hole is required to be pre-drilled into the 

ventilated wood shelf in every circumstance where screws are installed 

through the ExpressShelf Hardware and into the ventilated wood shelf.

STEP 1 - Measure

STEP 4 - Measure and Cut Shelf to Size

STEP 2 - Install the Backwall Channel

Measure corner to corner, and determine the desired height for 

each shelf. The backwall channel width should equal the wall 

measurment. The shelf width should be 5/8 in. to 1 in. (15.88 

to 25.4 mm) shorter than the wall and backwall channel.

Locate your cut on the shelf. Adjust your cut points to avoid deck 

slats. You may need to cut the shelf at two different points.

Do not cut along the deck slat.

STEP 3 - Install Sidewall Brackets

Slide edge or sidewall bracket into alignment with end of 

backwall channel at the return wall. Secure sidewall brackets 

using easy anchors and screws.

For stud mount:

 Level the backwall channel and fasten with 

appropriate screws directly into studs every 16 in. including 

the end slots using Easy Anchors and 1-1/4 in. wood screws 

if necessary.

For drywall mount:

 Level the backwall channel and mark easy 

anchor locations every 10 in. - 12 in. including end slots. Drill 

pilot holes as needed using sharp bit; but do not punch. Install 

drywall easy anchors into holes. Secure the channel through 

the channel slots with screws into the anchors.

STEP 5 - Install Shelf

Slide the back pre-grooved section of the ventilated wood shelf 

into the backwall channel so it fits securely all the way back into 

the channel.

2

Отзывы: