CLIVET WSAT-YSC4, Руководство пользователя

Страница: 32 / 76

Parameters Short description Description
P0002 En DemandLimit Enabling Demand Limit: 0 = disabled, 1 = analogic input, 2 = parameter
P0003 En WaterReset Enabling Water reset: 0 = Off, 1 = Cool, 2 = Heat, 3 = Cool and Heat
P0050 En 2SetPoint Enabling 2SetPoint: 0 = Off, 1 = On
P0036 En CompExt Enabling Climatic TExt: 0 = Off, 1 = Cool, 2 = Heat, 3 = Cool and Heat
P0051 PrioritaCmd
Status and machine mode priority: Local [0] = Priority to local commands, BMS [1]
priority to commands from plant supervisor
P0053 En DIOn-Off Enabling remote ON-OFF: 0 = Off, 1 = On
P0090 TypeDL Inlet signal type: 0 = 0-10V; 1 = 4-20mA
P0091 TypeWR Inlet signal type: 0 = 0-10V; 1 = 4-20mA
Compressor casing resistances
Connect the compressor oil heating resistances at least 8 hours
before the compressor is to be started:
 at the first unit start-up

after each prolonged period of inactivity
1 Power the heaters: isolator switch on 1 / ON.
2 Check the power consumption of the resistances to make sure
that they are functioning.
3 Start-up the compressor only if the crank-case temperature on
the lower side is be higher than the outside temperature by
at least 10°C .
4 Do not start the compressor with the crankcase oil below
operating temperature.
Voltage
Check that the air and water temperatures are within in the
operating limits.
Start-up the unit.
While the unit is operative, i.e. in stable conditions nearing
operating ones, check:
 Power supply voltage

Total absorption of the unit
 Absorption of the single electric loads
Options
Menu accessible only after having entered the password. Access
reserved only to specifically trained personnel.
The parameter modification can cause irreversible damages.
Path: Main menu / Unit parameters / Options
6 - START-UP