C. Art. M01B40M6
*E*%
$,5&22/('
:$7(5&+,//(5
:6$7
5&
,167$//$7,21
23(5$7,21$1'
0$,17(1$1&(0$18$/
*(1(5$/
THIS MANUAL CONTAINS THE FOLLOWING SECTIONS WHICH ARE TO BE CONSIDERED AN INTEGRAL PART
OF THE WHOLE AND ARE THEREFORE NOT TO BE DETACHED
G1B5GB-3
R1B5GB-3
E1B5GB-3
F1B5GB-3
C1B5GB-3
General
Reception/Positioning Electrical connections
Start-up
Control
T1B5GB-3
M1B5GB-3
L1B5GB-3
K1B5GB-3
Troubleshooting
Maintenance
Water connections
Residual Risks
,03257$17
The contents of this manual are designed to assure the
correct installation, adjustment and maintenance of the unit;
therefore:
−
read the instructions with due care and attention;
−
the appliance must be installed, tested and serviced by
properly qualified personnel (law n.45, 5.3.1990) licensed in
accordance with established legislation.
•
The manufacturer declines all liability, and guarantee
coverage is automatically waived, if electrical and/or
mechanical modifications are made to the unit. Tampering
and unauthorized repairs or modifications to the unit will
automatically void the guarantee.
•
Observe the safety regulations in force at the time of
installation.
•
Make sure that the characteristics of the mains network
conform to the data on the serial number plate inside the
electrical panel.
•
Conserve this manual and the circuit diagram with care.
Make sure that they are available for consultation by the
operator whenever necessary.
•
Packing materials (plastic wrappings, expanded
polystyrene, nails, etc.) are potentially hazardous and must
be kept out of reach of children. Recycle packing materials
in accordance with local bylaws.
•
The water chilled must be used only for the purpose for
which it is designed. The manufacturer bears no
responsibility in the case of applications other than the
specified use.
•
Disconnect the unit in the case of breakdowns or
malfunctions.
•
If repairs are necessary use only Clivet-approved service
centres and always insist on original spare parts.
The use of non-original parts and/or unauthorized service
centres may result in unsafe operation of the unit.
The manufacturer declines all liability for direct or indirect damage to property or injury
to persons resulting from failure to adhere to the instructions in this manual.
$'',7,21$/6$)(7<35(&$87216
This unit has been especially designed and manufactured so to prevent any risk to persons and health hazard.
For this reason, design solutions fit to eliminate (where possible) any cause of risk and sensibly reduce the probability of
danger have been adopted.
Please refer to the RESIDUAL RISKS section of this manual and strictly observe the behaviour prescriptions listed there in
order to prevent any possible risk that hasn’t been possible to avoid in the design stage.
