M23740N6-03 01/10/07
page
8
RECEPTION
INSPECTION UPON RECEPTION
Check on arrival that the unit has not suffered damage
during transit and that it is complete in every part as
specified in the order. In the event of visible
damage/deficiencies being discovered, make a note
immediately on the delivery document with the comment:
CONDITIONAL ACCEPTANCE — CLEAR EVIDENCE OF
DEFICIENCIES/DAMAGE DURING TRANSIT
Inform both the supplier and the carrier of the details by fax
and by registered mail with advice of receipt not later than 8
days after taking consignment. Notifications sent after 8
days have elapsed will be ignored.
STORAGE
Shelter from: direct sunlight, rain, sand and wind
Temperature: maximum 60°C minimum -10°C
Maximum humidity: 90%
The respect of the instructions on the exterior side of the
packaging assures the physical and functional integrity of
the unit for the final user’s advantage.
It is recommended to:
•
Handle carefully
•
Keep in a dry place
•
Avoid putting other objects on top of the unit (respect
the limits of levels of superimposition shown in the
package)
•
Avoid placing the unit with thermoretractable protection
under the sun since the pressure of the circuits can
assume values which activate the safety valves.
HANDLING
The operation of handling the unit must be carried out
respecting the instructions of the safety norms in force
(Legislative Decree 626/94 and following modifications)
Before starting the handling operations:
•
Value the critical points during handling (stairs, flights,
disconnected routes, doors, etc)
•
Verify that the lifting capacity of the means used is
adequate to the unit weight
•
Consider that the barycentre could be moved with
respect to the center of the unit
•
Before starting to lift, verify that the unit is at a stable
balance
The following examples are indications; the choice of the
means and of the handling modes will depend on factors,
such as:
•
The unit weight
•
Type and overall dimensions of the unit
•
Place and route for the handling (dirt yard, asphalted
square, etc)
•
Condition of the place of destination (roof, square, etc)
•
Handling distance characteristics (distances, flights,
steps, doors)
LABELS / YELLOW BRACKETS SHOW THE LIFTING POINTS
Rigid structure to prevent damage to the
structure
Position U-shaped clips on base
Anchor belt to clips
Close with threaded pin.
Ensure that the unit is stable and balanced.
Keep in mind that the centre of balance may not
be at the centre of the unit.
Ensure that the unit is stable and balanced.
Keep in mind that the centre of balance may not
be at the centre of the unit.
REMOVING THE PACKING
For removing the packaging, use specific personal
protection for the operator (gloves, glasses, etc.).
While removing the packaging, pay attention not to damage
the unit.
Check for any visible damage.
Dispose of the packaging by taking it to specialist collection
or recycling centres in accordance with local regulations.
