Clipper C13SPE, Руководство пользователя

Страница: 13 / 30

13
Additional Guide Lines For Sawing:
•
Understand and follow all of the instruction in this owners manual.
•
If wet cutting, turn on the water supply so that there is a minimum of two
gallons per minute of water flow!!
•
In critically hard aggregate more than a single pass may be needed to cut
the desired depth.
•
Only move the Engage/Disengage lever while the transmission speed
control is in the neutral position.
•
Move the transmission speed control slowly.
•
If the saw stalls in the cut, immediately stop the forward speed and raise
the blade out of the cut. If this is not done the belts can fail or the blade
may be damaged.
•
Go slowly with a new blade until it opens up, that is, until the diamonds
can be seen and felt.
•
If the saw leads off excessively check the contact between the drive rollers
and the rear wheels. Small steering corrections may be made by applying
slight pressure to the right or left side of the handle bar. The drive rollers
will need to be cleaned from time to time.
F. Lead-Off Adjustment
If the saw tends to lead off (cut to one side), it may be steered by applying
slight pressure to the left or right hand handles.