Clipper BBC157, Руководство пользователя

Страница: 23 / 36

23
Note: Never operate saw without bearing cover in place.
For normal conditions the grease should conform to the NLGI grade two consistency
and be free of any chemical impurities such as free acid or free alkali, dust, rust, metal
particles or abrasives.
For best results, the bearings should be lubricated while in operation.
Note:
Due caution for personal safety must be observed when servicing rotating
equipment.
If necessary to lubricate while the bearing is idle, refer to lubrication table for the
maximum grease capacity for the bearings.
LUBRICATION OF SEALMASTER BEARINGS
Shaft Sizes Maximum Grease Capacity of Bearing
Chamber in Ounces
1/2" to 3/4" .09
7/8" to 1-3/16" 1/4
1-1/4" to 1-1/2" 3/8
1-11/16" to 1-15/16" 3/4
2” to 2-3/16" 1-1/8
E. Pump
The submersible pump is mechanically driven by the V-belts and the sealed bearings
require no lubrication. The pump is designed to run wet or dry, but for continued dry
cutting, disconnect the pump.
1. Be sure to keep the pump clean - do not allow sediment to cake in the pump and
clog it.
2. Keep all lines clean and running free.
3. Do not allow the Flex-cable to be pinched by the blade guard or anything else.
Damage to the flex cable by pinching is not covered under any warranty