TROUBLE SHOOTING
ProBLeM:
Table height adjustment will not work properly.
SOLUTION: Make sure the table is connected to a working electrical outlet. Inspect all power cords
for cuts or breaks that would interfere with the electrical connection. Check to make certain foot
pedal cord is properly and securely plugged into motor. If after checking all these areas, the table will
not operate, or operates improperly, call a technician, or call Clinton Industries at 800-441-9131 for
assistance.
For assistance with other problems not covered in this guide, or questions about your
Clinton Power Table, please call Clinton Industries at 800-441-9131.
REMOVAL OF THE MOTOR FOR SERVICE
The motor assembly is located at the foot-end of the table on the base. If possible, raise the table to its
highest position. Disconnect the power cord. Remove the three screws on each side of the top portion
of the shroud. After removing the screws, gently guide the top portion of the shroud over the bottom
portion. Using help, lower the table onto its side onto a protective surface such as a blanket or other
material that will not harm the upholstered top. Next, detach the motor assembly. Remove the foot
pedal controller by unplugging the DIN plug on the side of the motor. Carefully remove the upper and
lower motor mount bolts to free the motor assembly.
To reassemble reverse the process to attach the motor. Using help lift the table from its side into the
upright position and reattach the shroud by raising the top portion by hand into position and reattach
with screws. DO NOT lower the table to reattach the shroud.
Upper Motor Mount
Motor assembly
Foot Pedal dIn Plug
Lower Motor Mount
(continued)