CLIMIA CMK 2950, Руководство по эксплуатации

Страница: 15 / 24

Local room air conditioner CMK 2950
9.0 Commissioning
Before every commissioning the air
inlet and outlet openings should be
checked for foreign bodies and the
air inlet filter must be checked for
dirt. Blocked or soiled grills and filters
must be cleaned immediately, see
"Care and maintenance" chapter.
Cooling mode
1. Switch the unit on with the “I/O”
key.
2. Select cooling mode with the
"MODE" key.
3. Set the desired target
temperature with the "THERMO/
TIMER CONTROL" keys. The
selected target temperature will
be shown in the display. If the
fan speed selected is too large
or too small then this can be
adjusted with the "FAN" key.
Recirculation mode
1. Switch the unit on with the “I/O”
key.
2. Select recirculation mode with
the "MODE" key.
Via a wall pass-through
The hose supplied is firmly attached
to a wall pass-through. A suitable
wall pass-through is available as an
accessory
(Fig. 6)
.
10.0 Shutdown
Temporary shutdown
If it is planned to shut down the unit
for longer periods e.g. during the
winter, proceed as follows:
1. Let the unit run in recirculating
operation for approx. 2 hours
in order to dry the surfaces
of the evaporator fins. This
will transport the remaining
moisture out of the unit and
this will avoid unpleasant
odours when the unit is re-
commissioned.
2. Switch the unit off with the "I/O"
key, pull out the power plug
and wind up the power supply.
Ensure that the cable is not
kinked or too severely bent. The
line can be fastened to the rear
of the unit.
3. Place a suitable container
underneath the condensate
drain of the internal reservoir.
The condensate drain is located
on the lower rear side of the unit.
4. Pull out the stopper from the
condensate drain and collect the
condensate that drains out.
5. Then insert the stopper once
again.
A missing stopper or an
incorrectly inserted stopper will
result in condensate leaking out
after re-commissioning.
NOTE
In some circumstances routing
the exhaust air via a firmly
attached exhaust air hose,
e.g. through closed doors or
windows, can lead to negative
pressure in the room in which the
unit is being used. If this should
reduce the performance of the
unit then arrange for the pressure
to be equalised.
Fig. 4 Exhaust air with open window
Fig. 5 Exhaust air with tilted window
Fig. 6 Wall pass-through
NOTE
Never switch off a running unit
by pulling out the power plug!
15