Climax VST-2735 Series, Руководство пользователя, Страница: 28 / 60

25
User PIN code and press the Away
Arm key on the Remote Keypad.
(Please refer to Remote Keypad
manual for detail)

Press the Away Arm key on the
Remote Controller.

When under Disarm mode, press the
Away Arm key on the Control Panel
for quick arm. (Quick Key arming must
be enabled in Panel Setting)

Use the Control Panel webpage to
Away Arm the Control Panel. (VST-
2735 and VST-2752 only, Please refer
to the IP installation Guide for detail)

Send an SMS command (Please refer
to
5. Vesta EZ Home Application ).
Step 2. The Control Panel will begin Exit
Delay Timer countdown according to
the setting. The screen will display:
T i m e t o e x i t
X X X s e c
Step 3. When the timer expires, the Control
Panel will enter Away Arm mode and
emit a long beep to indicate.
<IMPORTANT NOTE>

If Final Door is set to ON , when the
Door Contact set to Entry Attribute is
closed. The Control Panel will enter
Away Arm mode even if the Exit Delay
Timer has not expired yet.

Stopping the Exit Delay Timer
The Exit Delay Timer can be stopped by
disarming the system and the Control Panel
will return to Disarm mode. Please refer to
4.5.
Disarm Mode section below
4.4. Home Arm Mode

The Home Arm Mode allows the home
to be Partial Armed, Thus, part of the
System is protected with the Alarm,
yet, the other areas allows the user to
move freely without self triggering the
alarm.

Devices with their attribute set to
Interior, Follwer or Interior will not be
triggered under Home Arm mode.

Entering Home Arm mode
Step 1:

Select Home Arm under User Menu
and press OK .

When under Disarm mode, enter a
User PIN code and press the
Home
Arm key on the Control Panel.

When under Disarm mode:
Enter a User PIN code and press the
Home Arm key on the Remote
Keypad.
Press the Home Arm key on the
Remote Controller.

When under Disarm mode, press the
Home Arm key on the Control Panel
for quick arm

Use the Control Panel webpage to
Home Arm the Control Panel.
(Ethernet models only, please refer to
the IP installation Guide for detail)

Send an SMS command (GSM
models only, please refer to
5.Vesta
EZ Home Application ).
Step 2. The Control Panel will begin Exit
Delay Timer countdown according to
the setting. The screen will display:
T i m e t o e x i t
X X X s e c
Step 3. When the timer expires, the Control
Panel will enter selected Home Arm
mode and emit 3 short beeps to
indicate.

Stopping the Exit Delay Timer
The Exit Delay Timer can be stopped by
disarming the system and the Control Panel
will return to Disarm mode. Please refer to
4.5.
Disarm Mode section below
4.5. Force Arm
When you arm the system, if any fault event
exists in the system, the arming action will be
prohibited and the fault event will be displayed
on screen.
At this moment, you can either rectify all of the
problems and clear the Fault Display. The
Control Panel will be able to be armed
normally.
If you want to arm the system without
correcting the fault situation, follow the steps