2
¾
Request
for
Home
mode during
Arm
mode.
¾
Request
for
Force
arm
.
z
Fault LED (Amber):
z
Flash: system failure (panel tamper, AC fault, sensor temper, sensor out of order, open door)
z
On: Alarm Memory (depend on Control Panel).
z
Power
z
Remote keypad uses one EL123AP 3V Lithium battery as its power source.
z
Remote keypad can also detect the battery status. If the battery voltage is low, the Active LED will flash (
Amber
in
Test
mode
or
Blue
in
Normal mode
) during operation. The Low battery signal will be sent along with regular signal
transmissions to the Control Panel for displaying the status accordingly.
z
Before shipment, the battery is pre-installed by the factory. Pull out the battery insulator to activate battery.
z
When changing battery, press the tamper switch a couple time after removing old battery to discharge, then insert the
new battery.
z
Power Saving Feature
z
When idle, Remote keypad is in
Stand-by
mode and uses no power. It will activate and
wake-up
for 5 seconds when
any key is pressed.
z
After 5 seconds of key inactivity, the power goes off and it returns t
o Stand-by
mode.
z
Upon completion of a command input, the power goes off and Remote keypad returns to
Stand-by
mode.
z
Test Mode
z
Remote keypad can be put into Test mode by entering the Keypad PIN code (default:
0000
) followed by
＊
key. The
Active Amber LED will turn on along with a long beep.
z
To exit Test mode, press
key
twice
, Remote keypad will sound a long beep and the Active LED will turn off
,
then
Remote keypad returns to Normal Operation mode. Otherwise, Remote keypad will automatically exit Test mode after
5 minutes and return to
Normal Operation mode.
<NOTE>
&
The Test Mode is helpful for bypassing Remote keypad Tamper alarm when installing, replacing low batteries or
removing to different mount site.
&
When Remote keypad is in Test mode, it operates as
wake-up
condition and will NOT disconnect after 5 seconds.
Test Mode Function:
Press
＊
key and then
7
key — Transmit Remote keypad learn signal
Press
＊
key and then
2
key — Enable Dual-key Panic Alarm function
Press
＊
key and then
3
key — Enable Dual-key Fire Alarm function
Press
＊
key and then
4
key — Enable Dual-key Medical Alarm function
Press
＊
key and then
5
key — Disable all Dual Key function (
Default
)
Press
＊
key and then
6
key — Edit Keypad Pin Code
Enter
Old
Keypad Pin Code and then press
Χ
key
Enter
New
a new 4-digit Keypad Pin Code and then press
#
key
.
Press
key
twice
— to leave the Test Mode
.
Press
＊
key and then
8
key — Enable Arm/ Home without PIN Code function
Press
＊
key and then
9
key — Enable Arm/ Home with Control Panel User PIN Code function (
Default
)
z
Tamper Protection
z
The keypad is protected against any attempt to open the lid or to detach keypad from its mounting surface.
z
Tamper protection is disabled when the keypad is in Test Mode.
z
Installation Procedures
Step 1.
Put the Control panel into learning mode, .
Step 2.
Adding remote keypad into the Control Panel:
Test Mode Learning:
I.
Put remote keypad in Test mode by entering KP PIN code (default:
0000
), then press
＊
key. The Active
Amber LED will turn on along with a long beep sound.
II. Press
＊
key then
7
key. Remote keypad will sound a long beep.
