24
6.2. Current Operation Condition
CH-MG uses its LED to remind the user of its Current Operation Condition.
LED indicators:
LED
Behavior
Indication
LED (Red)
Flash
During Guard Time
LED (Blue)
1 Flash every 2 seconds
In learning mode
LED (Amber)
All LEDs On
During Remote Update
1 Flash every 3 seconds
Panel Low Battery/ Cellular
Network fault/battery
disconnected
1 Flash every 5 seconds
Device low battery/Device
tamper/Device out-of-order
LED (Green)
ON
AC power connected
Flash
AC power disconnected
If CH-MG is activated while having a Cellular Network fault (Amber LED
flashes once every 3 seconds), it will play voice prompt “Poor cellular
connection. Please call 911.”
6.3. Test Mode
Test Mode is for user to test if the CH-MG can make a successful report to
the CMS.
To enter Test Mode:
Step 1.
Press and hold the Info button for 3 seconds. CH-MG will emit
one beep at 1
st
and 3
rd
second. Release the button after the beep
at 3
rd
second to enter Test mode.
Step 2.
CH-MG will play voice prompt “Entering Test Mode, press the
Help Button to connect to the test center.”
Step 3.
Press the Help Button once to continue with the Test. If no action
is taken, CH-MG will come out of test mode in 5 minutes.
6.4. Alarm Activation
When an alarm is activated by pressing the Help Button of CH-MG or the
learnt-in RF device (WTR, Fall Sensor or PB), or pulling the cord of PCU,
CH-MG will emit a voice prompt “Connecting” as it enters guard time
(default 10 seconds).
If alarm is activated by fall detection, CH-MG will enter guard time fall
sensor (default 30 seconds).