Climax BB4500, Руководство по эксплуатации

Страница: 54 / 162

Page 38 BB4500-BB5000 Operating Manual
The AFU may be set anywhere
along the bar. It is not necessary to
insert the leadscrew directly into
the RDU. The leadscrew may be
screwed into the tack weld block
that may then be welded or
clamped directly to the workpiece.
CAUTION
Take care not to bend or
unduly stress the leadscrew
during installation.
Do the following:
1. Carefully slide the bar through the spherical mounting bearings.
T
IP
:
If positioning the AFU between the mounting support brackets, slide it
onto the bar at this point rather than in step 10.
2. Insert the bar into the opposing bearing bracket.
3. Install the RDU onto the bar, positioning it against the spherical bearing
bracket so that one of the spring pins engages one of the slots in the bearing
mount.
4. Tighten the clamp ring to 30 ft-lbs (41 Nm). Slide the bar to see if it is free
to move. If it does not move, the clamp ring is too tight. Loosen the clamp
ring bolt until the bar has some resistance but moves freely.
CAUTION
The clamp ring must be tightened before the machine is turned on. Do
not rely on the spring pins to hold the rotational torque of the machine.
5. Tighten the clamp collar over the collet, as shown in Figure 3-11 on page
39. Turn the collar screw until the collar is snug, but the bar slides easily
through the unit. In most boring applications, this collar can remain loose.
F
IGURE
3-10. P
OSITIONING THE
AFU