Climax AUTOBOREWELDER BW3000, Руководство по эксплуатации

Страница: 57 / 150

P/N 52815, Rev. 7 Page 43
3. Press the ROTATE JOG button or manually rotate the offset head to rotate
the torch from the 3 o’clock position (Point C) to the 9 o’clock position
(Point D). Note the distance from the torch nozzle to the bore surface at
these positions.
4. Loosen the radial mount clamp knob and pivot on the mounting rod to cen-
ter the torch between Points C and D. Accuracy within 1/16" (1.6 mm) is
sufficient for most applications.
5. Lock the radial mount clamp knob (15 ft-lbs [20 Nm] maximum torque) to
prevent movement of the BoreWelder and subsequent loss of centering.
3.3.8 Understanding the boring bar interface
A boring bar interface may be used instead of the CLIMAX adjustable base (for
full details, please consult the operating manual from the boring bar manufac-
turer).
When using a boring bar interface in the horizontal axis, it’s helpful to position the
interface so the mounting rod is above the hole to be welded. This will ease center-
ing adjustments since the BoreWelder will be hanging from the mounting rod.
Centrality adjustment is normally limited to one axis: the Y or swing axis from the
mounting rod. Section 3.3.7 explain how to center on the Y axis.
In most cases the boring bar interface eliminates the need for parallelism adjust-
ment, since the interface is trued to the boring bar and, consequently, the bore. In
situations where parallelism is inaccurate, please refer to your boring bar manual
for adjustment information or contact CLIMAX directly.
3.3.9 Adjusting the reach
The BoreWelder should be positioned on the mounting rod so that the axial torch
travel will reach the beginning and end of the bore (if the bore is shorter than the
stroke of the BoreWelder). You have two options for positioning the BoreWelder.
Option 1: Add or remove extensions to change the reach without moving the
BoreWelder on the mounting rod.
Option 2: Slide the BoreWelder up or down the mounting rod.
3.3.10 Attaching the wirefeed conduit and loading wire
1. Attach the BoreWelder end of the wirefeed
conduit to the swivel connector located at the
top of the BoreWelder by engaging the attach-
ment nut. Tighten by hand only, as the seal is
obtained with an O-ring.
2. Open the wirefeeder case.
3. Loosen the thumb screw of the feeder conduit
fitting.
F
IGURE
3-10. S
WIVEL CONNECTOR