3
Step 2: Put the Control Panel into learning mode, refer to Control Panel manual for detail.
Step 3: Press the Learn/Test Button on
Door Contact to send signal to the Control Panel.
Step 4: If the Control Panel successfully receives the signal, the Control Panel should respond (e.g. emitting
beeps). Refer to your Control Panel manual to complete the learning process.
Step 5: After the Door Contact is learnt-in, put the Control Panel into “
Walk Test
” mode, hold the Door
Contact at the desired location, and press the Test button to confirm if this location is within signal
range of the Control Panel.
Step 6: When you are satisfied with the Door Contact at the chosen location, proceed to
installation
.
Installation
Installation Guideline
Mount the Door Contact on the fixed frame of door/window using
Screw Mounting
or
Adhesive
Mounting
.
Mount the magnet on the mobile object (door/window) using
Screw Mounting
or
Adhesive
Mounting
.
The rib marks on the Door Contact and the magnet must align. When required, use the Magnet Spacer
to better align the magnet to the rib marks.
< NOTE >
The magnet should be no more than
15mm
from the Door Contact when the door is closed.
Mounting Methods
Screw Mounting
The back cover of the door contact and the back cover of the magnet each have two mounting holes.
To mount the Door Contact:
I. Open the top cover, and use a flat-head screwdriver to remove the back cover of the door contact.
II. Using the mounting holes as a template, drill holes on the wall for plugs.
III. Insert wall plugs and screw the back cover into the wall plug using a Phillips screwdriver.
IV. Attach the body of the door contact onto the back cover by fitting the right hooks of the body into the
right latches of back cover, then close it until you hear a clip sound. Make sure the tamper switch is
properly depressed against the tamper switch location. (See
Figure 2
below).
V. Replace the top cover by sliding it to the right. Tighten the retaining screw (See
Figure 1
above for
details).
To mount the Magnet:
I. Use a flat-head screwdriver to remove the back cover of the Magnet.
II. Using the mounting holes as a template, drill holes on the wall for plugs.
III. Insert wall plugs and screw the back cover into the wall plug using a Phillips screwdriver. Where
required, use the Magnet Spacer to better align the magnet to the rib marks.
IV. Attach the magnet onto the back cover with a click sound.