MODE & FAN OPERATION
9
10
DRY (DEHUMIDIFYING) MODE
Turn on the unit by pressing the I/O button on the remote control.
Press the Mode Button until the “DRY” appears on the LCD display.
NOTE: The unit operates at low fan speed during dehumidifying. The unit cools room
Keep the windows and the doors closed to aid the effectiveness of the unit in
removing the moisture from the room.
than 61°F or 16°C).
FAN MODE
Turn on the unit by pressing the I/O button on the remote control.
Press the Mode Button until “FAN” appears on the LCD display.
Select the fan speed by pressing the Fan Speed Button.
The HIGH, MED and LOW fan speeds can be chosen for the following modes:
AUTO, COOL, FAN and HEAT. Only the LOW fan speed is available for DRY mode.
HEAT MODE
Turn on the unit by pressing the I/O button on the remote control.
Press the Mode Button until “HEAT “appears on the LCD display.
Press the +/- Temperature button until the desired room temperature appears on the
LCD. The temperature ranges from 61°F to 88°F (16°C to 31°C).
Select the fan speed by pressing the Fan Speed Button. It is recommended to use
a low fan setting.
MODE & FAN OPERATION
SLEEP
Turn on the unit by pressing the I/O button on the remote control.
Press SLEEP to enter into sleep mode.
The fan motor of unit runs in low speed.
1°F per hour. Then temperature will stay at 2°F higher than the original temperature
for 8 hours. After 8 hours, the temperature will return to original temperature.
1°F per hour. Then temperature will stay at 2°F lower than the original temperature
for 8 hours. After 8 hours, the temperature will return to the original temperature.
When in dehumidify mode, the temperature will not be changed.
TIMER FUNCTION
To set the timer to turn the unit On or Off: Press the “T-On” key; the clock and the
word “ON
Hour and Min buttons until the desired on
and the timer will be set.
To set the timer to turn off, repeat the same steps with the “T-Off” key.
Note: Timer can only be set in 10-minute increments.
NOTE: You can set either T-ON or T-OFF; also can set both T-ON and T-OFF. If you
set both T-ON and T-OFF simultaneously, the timer will always cycle effectively
unless removed either T-ON or T-OFF
POWER OUTAGE RECOVERY FEATURE
In the case of a power outage or interruption, the unit will automatically re-start in
the settings last used after the power is restored. If the Delay 1–24hr feature was
set, it will resume countdown. If desired, a new time may be set.
