ClimateMaster 38 WQ-S018SSC301, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 31

Page 15
All field installed wiring, including electrical ground,
must comply with the National Electrical Code as well as
all applicable local codes.
Refer to the unit wiring diagrams for fuse sizes and a
schematic of the field connections which must be made
by the installing (or electrical) contractor.
Consult the unit wiring diagram located on the inside of
the compressor access panel to ensure proper electrical
hookup.
All final electrical connections must be made with a
length of flexible conduit to minimize vibration and
transmission.
General Line Voltage Wiring
Be sure the available power is the same voltage and
phase as that shown on the unit serial plate. Line and low
voltage wiring must be done in accordance with local
codes or the National Electric Code, whichever is
applicable.
GT-S Power Connection
Line voltage connection is made by connecting the
incoming line voltage wires to the “L” side of the
contactor as shown in Figure 14. Consult Table 7 for
correct wire and fuse size.
External Loop Power Connection
If the unit is to be used with an external loop pump, the
pump(s) will be connected to the loop pump wires in the
flow controller compartment as shown in Figure 3. The
pumps will automatically be cycled as required by the
unit.
To avoid possible injury or death due to electri-
cal shock, open the power supply disconnect
switch and secure it in an open position during
installation.
CAUTION: Use only copper conductors for
field installed electrical wiring. Unit terminals
are not designed to accept other types of con-
ductors.
ELECTRICAL - LINE VOLTAGE
Table 7 GT-S Electrical Data.
Figure 14. GT-S Line Voltage Field Wiring.
FCR
CRR
CCM PCB
HPS
LPS
Y
X
C
T
Note: See FC Mounting for Flow Controller Wiring
Consult Electrical Table for wire and fuse size.
All power wiring per local code
C
A
L
R
O
Y
CRC
Grnd
L2 L1
T2 T1
CC
R a t e d V o l t a g e Compressor E x t Total Min Max S u p p l y
M o d e l V o l t a g e Min/Max P u m p Unit Circ F u s e / Wire
M C C R L A L R A F L A F L A Amp H A C R Min AWG Max Ft
018 208-230/60/1 197/254 11.0 7.1 39.0 4.0 11.1 12.9 20 12 90
024 208-230/60/1 197/254 16.0 10.3 56.0 4.0 14.3 16.8 25 10 120
030 208-230/60/1 197/254 19.0 12.2 67.0 4.0 16.2 19.2 30 10 100
036 208-230/60/1 197/254 21.0 13.5 73.0 4.0 17.5 20.8 30 10 100
042 208-230/60/1 197/254 25.8 16.5 95.0 4.0 20.5 24.7 40 8 120
048 208-230/60/1 197/254 28.6 18.3 109.0 4.0 22.3 26.9 45 8 110
060 208-230/60/1 197/254 39.0 25.0 169.0 4.0 29.0 35.2 60 6 140
HACR circuit breaker in USA only
Wire length based on one way measurement with 2% voltage drop
Wire size based on 60°C copper conductor
All fuses Class RK-5