EVAPORATIVE CM-6000A
www.climateplus.ae
Guide for Operation
Introduction of the function of the button on the remote controller:
Introduction of the function of the button on the remote controller
1)
ON/OFF: Start the cooler in stand-by state or stop
2)
COOL: Switch to cool mode or ventilation mode
3)
DRAIN: Start or stop draining water
4)
: Add the airflow for the conversion from low speed, mind
Speed and high speed, the rank is 1-2-3-1
5)
Airflow-: Decrease the airflow for the conversion 1 speed-anion-1
speed
6)
SWING: start or stop swing
7)
TIMER: Start timing function
8)
ANION: Switch on/off the function of anion or ozone( due to the
matched system)
9)
Show: Show control board light picture or not.
Operating introduction
Please ensure the power lines are connected correctly before using!
1)ON/OFF:
Press this button under the state of stand-by, then it will start running. The mode and the
airflow will be the same as the last state when you power off it. The speed is at 2 speeds and
the cool function is ON when you power it at first time. The airflow will be showed at the range
of L,M,H from the left to right dynamically.
Press this button while the cooler is operation, it will stop and only the temperature will be
showed on it.
04
