EVAPORATIVE CM-6000A
www.climateplus.ae
Guide for operation
Introduction of the LCD controller
1.
ON/OFF: Start the cooler in stand-by state or stop
2.
COOL: Switch to cool mode or ventilation mode
3.
DRAIN: Start or stop draining water
4.
A: Add the airflow for the conversion from low speed
5.
Airflow-: Decrease the airflow for the conversion 1 speed-anion-1 speed
6.
SWING: Start or stop swing
7.
TIMER: Start timing function
8.
ANION: Switch on? off the function of anion or ozone (due to the matched system)
9.
SHOW: Show control board light picture or not
Operating introduction
1)
ON/OFF:
Press this button under state of stand-by, then it will start running. The mode and the
airflow will be the same as last state when you power off. The speed is at 2 speed and the
cool function is ON when the power it at first time. The airflow will be showed at the range
of L, M, H from left to right dynamically.
Press this button while the cooler is operating, it will stop and only temperature will be
showed on it.
2)
Airflow adjustable:
Press “airflow” button on the LCD controller or “airflow-” on the remote controller to
increase or decrease it. It can be change from L-M-H-L-M-H and that will be showed on the
“airflow indicator”
10
