13
latches
latches
3 to 5 mm tip
ƒ
Release the back wall mounting
plate. There are four latches, as
illustrated in the figure, two at the top
and two at the bottom of the
thermostat. Use a screwdriver with a
tip between 3 and 5 mm to gently
release them. After releasing each of
the latches, pull the respective device
corner a little to keep the latch from
snapping in again. Pull the device
straight out from the back mounting
plate after releasing all four latches.
„
Position the mounting plate on the
wall. Use a pencil to mark the
mounting holes. Remove the plate
from the wall and drill 3/16” holes in
the wall. Tap anchors into the drilled
holes. Reposition the plate and
loosely insert two mounting screws in
the holes. Level the plate for
appearance. Tighten the mounting
screws.
?
You may also use it over a standard
60x60x40 mm conduit box. The screw
holes match the holes of the conduit box
and cover the box completely.
Installing the device easily
