Clifford AvantGuard 4, Руководство по установке

Страница: 16 / 24

FACT—False Alarm Control and Test
The system microprocessor automatically checks for another activated sensor or trigger before sounding the siren a second time, thus
preventing any further false alarms. If you wish to test FACT, simply:
1. Arm the sys tem with the re mote con trol.
2. Wait 10 seconds after the interior light turns off, then trigger the Proximity Sensor to activate the siren.
3. Do not disarm the system, let the siren complete its cycle.
4. Trigger the sensor again. The alarm should be silent.
5. Unlock and open a door. The alarm should sound immediately. You may now disarm.
Eight-Event TotalRecall
The system’s nonvolatile memory records the identity of the last eight activated or malfunctioning triggers and sensors:
1. With the ignition OFF, press and hold the blank side of the PlainView 2 Switch.
2. Press remote control button 1 to “arm,” and then again to “disarm,” and then release the button.
3. The LED will flash 1–10 times, pause, then flash 1–10 times, etc. Write down the number of flashes in each cycle.
4. Refer to the following chart. The first number you wrote down was the most recently activated trigger or sensor. The next number
is the second most recent, and so on up to as many as the last eight activations.
Num ber of LED flashes be tween pauses Trig ger/sen sor in di ca tion
1 flash Digital Dual-Zone Proximity Sensor 4
2 flashes Optional OmniSensor
3 flashes Digital Tilt/Motion Sensor
4 flashes Door Trigger
5 flashes Trunk Trigger
6 flashes Hood Trigger
7 flashes
An attempt was made to turn on the
ignition or start the engine while the system was armed
8 flashes
More than three consecutive incorrect
valet codes were entered while the system was in BlackJax mode
9 flashes BlackJax Activation
10 flashes System Power Interruption
5. If a sensor is often activated, decrease that sensor’s sensitivity (or reposition the sensor, if necessary). If a certain trigger is often
activated, check pin switch operation, verify that the pin switch is not exposed to moisture and check the trigger wire for possible
shorting.
16
Avant Guard 4/699