Page 11 of 15
Rev. G
Wiring Termination at CLiC Glass Panel
The wiring terminations at the CLiC Glass panel will occur at the upper corners of the glass panel. Therefore, the
framing and pre-wiring for the CLiC Glass panel must provide enough room along the top edge to hide the wire and
allow for secure wire connections. See the diagram below:
IMPORTANT:
R
EMOVAL OF PROTECTIVE FILMS CAN PRODUCE ELECTRIC SHOCKS AND SPARKS WHICH COULD CAUSE
DAMAGE TO CONNECTED ELECTRONICS
.
A
LL PROTECTIVE FILMS MUST BE REMOVED PRIOR TO CONNECTION OF THE GLASS CONTROLLER
!
WD-02.2 Dry Contact Connections
The WD-02.2 has been designed to accommodate many installation configurations and scenarios by utilizing a
flexible Dry Contact Input Circuit. This circuit allows a wide variety of switch devices, relays, or other automation
controllers to provide end user control of the CLiC Glass panel. These devices can include, but are not limited to:
•
Standard light switches
N
OTE
: U
SED FOR LOW
-
VOLTAGE TRIGGER ONLY AND
NOT CONNECTED TO LINE VOLTAGE
•
Occupancy Sensors
•
Relays and Switch outputs from automation controllers or remote-control systems
•
Doorjamb Plunger Switches
•
Magnetic Security Style Door Switches
SYSTEM LAYOUT EXAMPLES
Please review the following diagrams for example wiring scenarios:
Wire Routing and Connection Locations
Glass
Out A
Glass
Out B
