CLEVERSPA Monte Carlo, Инструкция по эксплуатации

Страница: 10 / 16

10
OPERATING YOUR CLEVERSPA
®
SETTING THE TEMPERATURE
Press
‘SET TEMP/LOCK’
and the numbers on
display screen will start to flash. Increase/
decrease temperature by pressing
‘TEMP UP’
or ‘TEMP DOWN’ .
Choose desired temperature, press ‘SET TEMP/
LOCK’ again to confirm. Temperatures can be
set between the range of 5°C to 42°C .
(See safety instructions for recommended
operating temperatures).
INFLATE/AIR JETS
Press ‘INFLATE/AIR JETS’ to start air jets - a red
light will appear. Press again and air jets will
stop working - red light will go out.
Air jets stop automatically after 20 minutes.
To reset, wait for 10 minutes and press
‘INFLATE/AIR JETS . Air jets can be stopped/
started any time during their 20 minute cycle.
Air Jets will stop after 20 minutes to avoid
internal pump over-heating.
CONNECTING YOUR CLEVERLINK
®
APP
1. Check that your CleverSpa
®
is in a location with strong WiFi
coverage (see page 05).
2. Download the CleverLink
®
App on your Smart device, from the
App Store or Google Play.
3. Register your account.
4. Follow on screen instructions regarding how to pair CleverSpa
®
to your WiFi.
5. You are ready to go!
*Internet access required.
FILTRATION SYSTEM
Press ‘FILTER’ , red light will appear, pump will
start to work. Press ‘FILTER’ again to stop pump,
red light will go out.
After approx. 168 hours,
‘FC’ will appear on
display screen (flashing), with a warning tone.
Red light will be lit on
‘FILTER’
, pump
will not
be operational. Heating system will also not
work and red light will be off.
To make sure filtration system is off, press
‘FILTER’ . ‘FC’ on display screen will disappear
as well as warning tone. Water temperature will
be displayed, all functions will return to normal.
‘FC’
and warning tone remind user to replace filter.
‘FILTER
CHANGE’
HEATER
Press
‘HEATER’
, red light will appear.
Press ‘HEATER’ again and heating system
will stop, red light will go out.
When heater system is on, filter system will
switch on automatically to circulate water. When
temperature has reached 1°C above pre-set
temperature, heating system will stop working,
but light will remain on. Filter pump will
continue to operate even when heater
is not functioning.
When water falls
1°C below pre-set temperature,
heating system will automatically heat water
back to 1°C above selected temperature.
Once achieved, heater will stop to allow
temperature to settle at pre-set value.