CleverMic HDMI Series, Руководство пользователя

Страница: 52 / 63

Wireless network configuration:
Network interface enable: can check,to set the following items after checked.
DHCP: can check,if check,it can obtain IP automatically.
IP address:set wirelss WIFI IP(default 192.168.1.250,if checked DHCP,IP could assigned
automatically)
Note: wireless IP address can not be in the same segment with wired IP address.
Subnet Mask: Set the wireless IP subnet mask (default255.255.255.0)
Default Gateway: Set the wireless IP default gateway (default 192.168.1.1)
SSID: The user can modify their own (the default test)
Encryption: can check,the password can be set after checked.
Password: can set password,password can be changed if only checked encryption.
Click on the "Save" button to display "Parameter saved successfully" message,set to take effect
Note: SSID and password should be filled in correctly, otherwise, if restarted after the powered off, the wireless
WiFi connection is not successful.
2)WiFi hot link
Click on the “search” button to search the WIFI hotspot.
Double-click the dialog box after searched user WIFI hotspot,and then input password to connect WIFI. It
connected successfully after shown “successful connect” window.
3)Wireless WiFi login page
If you do not check the above configuration DHCP (automatically obtain IP),then open the browser,enter the
wireless network IP address in the address bar (default 192.168.1.250),press Enter to log construction;If you
checked DHCP,then you obtain IP automatically,just login specific router or switch user interface settings to view
the allocation of IP address.
5. Serial Communication Control
Under common working condition,the camera could be controlled through RS232/RS485
interface(VISCA),RS232C serial parameter are as follows:
Baud rate: 2400/4800/9600/115200 bits / sec; Start bit: 1; data bits: 8; Stop bit: 1; Parity: None.
After power on,the camera first go left,then back to the middle position.Self-test is finished after the zoom moved
to the farthest and then back to the nearest position. If the camera saved 0 preset before,it will be back to that
position after initialization.At this point,the user can control the camera by the serial commands.