Cleveland SteamChef 22CGT3, Руководство оператора

Страница: 11 / 30

4
The fan guard helps protect the operator from injury caused by the rotating fan blades.
Never operate a SteamChef without the fan guard properly installed.
Operating a SteamChef without the fan guard properly installed can cause injury, equipment
damage, and reduce performance.
CHAPTER 3
OPERATION
A. Main External Power Switch
•
Usually, the SteamChef’s Main External Power
Switch is left ON during operating hours. If the Main
External Power Switch is OFF, turn it ON as follows:
1. Turn the ON/OFF lever/switch to the OFF position.
2. The control panel settings are not important in this
procedure. The control panel circuits are not
powered while the ON/OFF lever/switch is OFF.
3. Refer to Figure 3-1 and turn on electric power to the
SteamChef at the Main External Power Switch.
B. Door Interlock Switch
The cooking compartment of the SteamChef is equipped with an automatic door interlock switch,
which turns OFF the burner, fan, and condenser, and stops the Timer when the door to a cooking
compartment is opened.
C. To Install/Remove the Fan Guard and Air Diverter
1. To Install the fan guard and air diverter:
a. Hold the fan guard so that the large ends of the keyholes are towards the bottom of the SteamChef.
b. Place all four openings over the mounts located on the rear wall of the SteamChef.
c. Pull it down so that the narrow ends of the slots are pulled tight over the mounts. See Figure 3-2.
d. Place the air diverter over the fan guard. Press lightly towards the rear wall until the air diverter drops
into its slots in the fan guard.
2. To REMOVE the fan guard and air diverter:
a. Lift the air diverter up and out of its slots in the fan guard.
b. Tilt the air diverter back and slide it over the fan guard.
c. Push up on the fan guard and slide the wide end of the slots over the mounts.
Burn and Scald Hazard
Even though the burner shuts off as soon as a door is opened, it may take up to a minute for production of
steam to end and residual steam in the system to clear from the cooking compartment.
To help avoid injury always wait until the residual steam clears and the convection fan stops before reaching
into the cooking compartment, and always wear dry heatproof gloves when reaching into the cooking
compartment. Wet or damp gloves conduct heat and can cause burns when touching hot items.
Failure to do so can cause burns, scalds, and other injuries.
SteamChef
MAIN EXTERNAL
POWER SWITCH
Figure 3-1
Main External Power Switch