6.
OPERATING THE UNIT
1.
Perform daily startup inspection.
FOR YOUR SAFETY:
Before commencing to cook, ensure pan is in the low-
ered position.
2.
MANUAL TILT:
Cleveland braising pans are equipped with a
manual tilt mechanism for raising and lowering the pan. To raise
pan, raise the cover and turn the crank clockwise. To lower pan,
turn counterclockwise.
POWER TILT:
Cleveland braising pans can also be equipped
with an optional electric power tilt mechanism for raising and
lowering the pan. To raise pan, raise the cover and press up on
the tilt switch. To lower pan, press down on the tilt switch.
3.
Toggle ON / OFF Switch to the "ON" position. The red Power
Indicator Light indicates power is on. The yellow Heat Indicator
Light indicates burners are on.
4.
To preheat, set Temperature Dial to desired cooking tempera-
ture. Unit is preheated when the yellow light goes out.
5.
Insert product in pan.
6.
If desired, once product has cooked, it can be held prior to
serving at a lower temperature setting.
7.
When cooking is completed, set Temperature Dial and
ON / OFF Switch to the OFF position.
8.
The best time to clean the unit is immediately after
use, once unit has cooled down. Refer to section
titled "CLEANING INSTRUCTIONS" for details.
OPERATING SUGGESTIONS
1.
Turn power switch to the "OFF" position when unit is not in use.
2.
Allow unit to preheat before adding product.
3.
Always lift the spring assist cover before activating the tilt mech-
anism.
4.
During an electrical power interruption, turn Power Switch to the
OFF position. This unit cannot be made to operate without elec-
trical power.
#
DESCRIPTION
1.
ON / OFF Switch
2.
Power Indicator Light
(red)
3.
Temperature Dial
4.
Heat Indicator Light
(yellow)
5.
Power Tilt Switch (loca-
tion may vary)
6.
Reset Button (location
may vary)
7.
Manual Tilt Override
OPERATING INSTRUCTIONS
1
2
OPEN COVER
BEFORE
TILTING PAN
!
HI
LO
6
4
1
2
3
5
7
POWER TILT
MANUAL
OVERRIDE
In case of power failure or
malfunction the skillet pan
can be tilted manually follow-
ing these instructions.
1.
(prior to May 2006) - Fit a 10mm SIX point socket over
the Manual Tilt Shaft as shown above.
(after May 2006) - Fit a 1/2” SIX point socket over the
Manual Tilt Shaft as shown above.
2.
Turn socket wrench clockwise to empty contents.
If for any reason this unit is not functioning correctly
DO
NOT OPERATE
. Contact your autorized service agent.
If for any reason this unit is not functioning
correctly
DO NOT OPERATE
. Contact your
autorized service agent.
• Casters must be locked at all times
(unless unit is being moved). Check
before use.
• Roll unit only on hard and smooth surfaces.
• DO NOT move unit with product in pan.
• DO NOT place unit on incline greater than 5 degrees.
Failure to follow these rules can cause serious injury
or death.
WARNINGS:
!
Содержание PowerPan SEL-30-T1
Страница 12: ...11 Schematic WIRING DIAGRAM CONSOLE COVER GEAR BOX PAN Point to Point ...
Страница 29: ...28 ...
