GENERAL
Installation of the kettle must be accomplished by
qualified electrical installation personnel working
to all applicable local and national codes.
Improper installation of product could cause injury
or damage.
This equipment is built to comply with applicable
standards for manufacturers. Included among
those approval agencies are: UL, NSF, ASME/Ntl.
Bd., CSA, CGA, ETL, and others. Many local
codes exist, and it is the responsibility of the
owner/installer to comply with these codes.
Note:
Maximum voltage for LVD (low volt
directive for Europe) to be 440 volts for CE
marked appliances.
INSPECTION
Before unpacking visually inspect the unit for
evidence of damage during shipping.
If damage is noticed, do not unpack the unit, follow
Shipping Damage Instructions shown below.
SHIPPING DAMAGE
INSTRUCTIONS
If shipping damage to the unit is discovered or
suspected, observe the following guidelines in
preparing a shipping damage claim.
1.
Write down a description of the damage or the
reason for suspecting damage as soon as it is
discovered. This will help in filling out the claim
forms later.
2.
As soon as damage is discovered or
suspected, notify the carrier that delivered the
shipment.
3.
Arrange for the carrier's representative to
examine the damage.
4.
Fill out all carrier claims forms and have the
examining carrier sign and date each form.
INSTALLATION
The first installation step is to refer to the
Specification Sheets or Specification Drawings for
detailed clearance requirements of the kettle.
Next, carefully cut open the shipping carton for
easy removal of the kettle.
ASSEMBLY
Table-top models (12 gallon) must be positioned on
a firm, level stand, or existing counter top, and
bolted in place. These models are supplied with four
threaded mounting bushings welded to the
underside of the base. An optional support stand
with level adjustable legs is available. Once the kettle
is secure, screw tilt handle into the threaded hole
provided at the right side of kettle.
Floor Type Leg Mount Models (20 gallon)
Position on a firm, level surface, and bolt flanged
feet in place. Once the kettle is secure, screw tilt
handle into the threaded hole provided at the right
of kettle.
ELECTRICAL
ENSURE THE ELECTRICAL SUPPLY MATCHES
THE KETTLE'S REQUIREMENTS AS STATED
ON THE RATING LABEL.
This kettle is built to comply with applicable
standards of manufacturers. Included among
these approval agencies are UL, NSF, ASME/Ntl.
Bd., CSA, ETL, and others. Many local codes
exist, and it is the responsibility of the owner and
installer to comply with these codes.
The electrical supply must match the power
requirements specified on the kettle’s rating plate.
The copper wiring must be adequate to carry the
required current at the rated voltage.
Note:
Maximum voltage for LVD (low volt
directive for Europe) to be 440 volts for CE
marked appliances.
INSTALLATION
