CLEOPATRA Complete Wellness, Руководство пользователя

Страница: 28 / 38

28
If you have chosen this option, the bath heater will keep the bath water on temperature as long
as the hydro system is switched on. Pay attention! The bath heater is not intended to heat up cold
water to the correct bath temperature.
If you have choosen for the option color light, there is a separate control
on the edge of the bath.
If you press the button, the green LED on the control unit will turn on and
the lighting will start with the first color. As long as you do not press the
button, the color light stays in that color. If you press the key again, the
next color will light up etc. At a certain moment the red LED on the control
lights up by pressing the key. From that moment on the system
automatically goes through the different colors. If you want one of these
colors to be shown for a longer period of time, immediately press the
button once. Do you want to turn off the lighting; then keep the button
pressed until the lighting turns off.
All spa systems, including the spa hydro systems and the extreme wellness systems, are equipped
with an auto-purge function. After about 20 minutes after the water is out of the bath, the spa
system automatically starts to blow the remaining water out of the air lines. This can also happen
when you clean the bath, the system registers as if water had been in the bath and will continue to
blow, that’s fine. The auto-purge function can also start automatically when, for example, a towel
was hanging over the edge of the bath (at the location of the water level sensor). Do not worry, this
does not damage your whirlpool.
6 All spa en hydro systems: Auto-purge function
7 Color light (optional)
8 Bath heating (optional)