User Manual : ZGAS
CLEODE
page
15
sur
21
III.5 Restart manually the pairing
To pair the ZGas again in a ZigBee® network, proceed as follows:
1)
Allow the addition of ZigBee® object in your
network (see the manual of your ZigBee®
coordinator)
2)
Hold 3 seconds the pairing button.
3)
If the ZGAS was not associated it will flash
rapidly during 20 seconds. The ZGAS is looking
for a coordinator during this flashing.
4)
If the association is successful, the red light
turns on for 2 seconds and then turns off.
The ZGas saves network parameters automatically on which it is already connected.
It is therefore possible in a network change (or when the network coordinator has been
changed) that the product can’t fit on the new network.
In this case, it is necessary to clear the existing network settings by performing a reset
procedure (see paragraph below).
If the light is not flashing after performing a long press of 3 seconds, the ZGas is already
associated in a network.
Appui long 3s
(Push during 3s)
