73
74
Figure 116
1
2
TO INSTALL SEAT CUSHION
Step 1
Insert the Buckle through the slot in the Seat
Cushion that matches the slot the Crotch
Strap is through in the seat.
Step 2
Insert the tabs on the back of the Seat
Cushion through the slots in the pad and into
the seat back at the back of the seat bottom.
Push the locking tabs at the lower front of the
Seat Cushion into the holes at the front edge
of the seat as shown in
Figure 116
.
Installing/Removing
Anti-Rebound Bar
TO INSTALL ANTI-REBOUND BAR
Step 1
Rotate Recline Foot to Rear-Facing position by
pulling on edge of Recline Foot and rotating
it forward until it locks in to position, as
shown in
Figure 117
.
Figure 117
lowered recline foot
Raised recline foot
Step 2
Remove Seat Cushion, see “Removing/
Installing Seat Cushion” on page 72.
Remove UAS Push-on Connectors from their
storage location, see “UAS Belt Storage” on
page 76.
Step 3
Insert the Anti-Rebound Bar into the holes in
the bottom of the seat on each side of the
Recline Foot as shown in
Figure 118
.
Step 4
Hold the Anti-Rebound Bar in place and
insert Locking Pins into the holes in the seat
and through the Anti-Rebound Bar as shown
in
Figure 119
. Check that each Locking Pin is
securely installed through both holes in the
seat and in the Anti-Rebound Bar and that
the Locking Pin Clips are through the Locking
Pins.
Step 5
If installing with vehicle belt, place UAS
Push-on Connectors back into their storage
location, see “UAS Belt Storage” on
page 76.
Figure 118
Figure 119
