77
78
Figure 124
2
1
Figure 123
Step 2
Place UAS Push-on Connectors in seating
area by inserting through Rear-Facing Belt
Path.
Step 3
Insert the UAS Push-on Connectors, with the
slots in the end oriented toward the outside of
the seat, into the openings at the front of the
seat bottom. As shown in
Figure 123
.
Step 4
Insert the UAS Adjuster
(1)
into the square
recesses behind the UAS Push-on Connector,
fold the excess UAS Belt
(2)
and insert under
tab between adjusters as shown in
Figure
124
.
Step 5
Install the Seat Cushion, see “Removing/
Installing Seat Cushion” on page 72.
Top Tether Storage
Removal:
Remove Instruction Manual and
Tether Belt from back of seat. Pull in and hold
retention spring on Tether Hook, then remove
hook from storage bar as shown in
Figure
125
, then replace Instruction Manual.
Storage:
Remove Instruction Manual from
back of seat. Hook Tether Hook around
storage bar as shown in
Figure 126,
fold
Top Tether belt and insert into Tether Storage.
Replace Instruction Manual.
Instruction Manual Storage
After carefully reading and following these
instructions, keep this manual for future use
and store in the compartment located in
Shoulder Harness Access Panel, as shown in
Figure 127
.
Figure 125
Figure 126
Figure 127
WARNING
• Read and understand product
labels and all instructions in
this manual and in your vehicle
owner’s manual before installing
or using this car seat.
• Failure to properly install or
use this car seat or follow these
warnings and those on this car
seat’s labels can result in serious
injury or death to the child
in a sharp turn, sudden stop
or crash.
C03-1422-CA
May2014
Fllo Instruction Manual
This car seat is designed for use either Rear-Facing or Forward-Facing by children who meet
all of the following requirements:
HEIGHT
WEIGHT
AGE
64 – 110 cm
25 – 43 in.
6.4 – 18.1 kg
14 – 40 lb
Able to sit
upright alone
HEIGHT
WEIGHT
AGE
76 – 124 cm
30 – 49 in.
10 – 29.5 kg
22 – 65 lb
2+ years
recommended
0234 5673
