Cleco NeoTek 30 Series, Инструкция по эксплуатации

Страница: 12 / 76

12 TM12-1109 |
2019-02 Apex Tool Group
1
EN
Warning in RUN SCREEN:
Tool Offline!
Tool has not been accepted
in the T
ool Settings
 Check the Tool List menu to make
sure that the tool has been
accepted. If it has not been
accepted, accept it
. The correct line
must be marked before the setting
can be accepted in the
Tool Settings
menu.
A faulty cable will prevent
the tool from being recog-
nized by the control.

Repair or replace cable
Different torque display in
the control and external
transducer Torque calibration factor
(Torque Cal.) in
Tool Set-
tings must be adjusted.
 Adjust Torque Cal. (Tool Settings)
using the following formula:

New calibration value = (external
value / tool value) x calibration value
used
Customer's angle attach-
ment was added to tool.
Tool memory must be
updated.  Reprogram tool memory
Tool cable does not fit in tool
handle 30/50 series tools require a
30/50 series tool cable.  Use the right cable for the tool being
used.
Malfunction Possible causes Remedy