10
P2309HW | 2018-09
Apex Tool Group
1
EN
5
Pin Assignment
This chapter describes the Cleco Production Tools specific
connectors. Standard plugs are not considered. All con-
nections are short-circuit proof.
X5, X6 – Serial port for additional devices
•
All outputs provide RS232 conforming signals.
•
The inputs allow voltages in the range from -15 V to
+15 V.
-
Voltages < 0.8 V correspond to a zero.
-
Voltages > 2.4 V are interpreted as a one.
-
Open inputs are preset to zero using a pulldown
resistor.
•
The power supply pins are connected directly to the
main board power supply
.
X7, X8 – Anybus CC
Optional slots for Anybus CC modules.
X21 – TSnet System Bus Out
Interface port for TSnet cable.
X22 – ARCNET System Bus
The station controller has an integrated bus termination;
therefore, no external termination is necessary.
X23 – Supply
X9, X10 – Input/Output
The required signal circuits are connected to these input/
output connectors. The signal groups are not galvanically
connected to the power supply; galvanic isolation is
required.
•
8 inputs/8 outputs, optically isolated for 24 V level/
0.5 A
•
Output current: 500 mA per output, 2000 mA total
Note
Do not connect or disconnect any device
during operation. Doing so may result in a
system reset.
Pin
X5
RS232-1
X6
RS23-2
9 Pin D-Sub Male
with Screw Lock
1
–
–
2
RxD
RxD
3
TxD
TxD
4
–
–
5
GND
GND
6
–
–
7
RTS
RTS
8
CTS
CTS
9
–
–
Pin
Signal
8 Pin M12 Circular Connector
X-Coded
1
Tx +
2
Tx -
3
Rx +
4
RX -
5
0 VDC
6
0 VDC
7
+24 VDC
8
+24 VDC
2
1
8
7
6
5
4
3
Pin
Signal
8 Pin M12 Circular Connector
A-Coded
1
N.C.
2
DATA-B
3
GND
4
+5 VDC
5
DATA-A
6
N.C.
7
0 VDC
8
+24 VDC
Description
IEC Connector C14
Connector with Fuse Holder
2-Pin, 5 × 20 mm, 16 A
Slow-Blow
Note
Use plug locking mechanism.
See Quick Installation Guide.
Note
A single device must not require a current of
more than 500 mA. The current monitor
switches off the output in the event of an
overcurrent.
2x12 Pin Phoenix MCD 0.5/24-G1-2.5
Mating Connector
Phoenix FK-MC 0.5/12-STZ3-2.5
Order no. S981211
Output (Sockel)
6
7
8
2
3
4
5
1
X9
X10