Cleco 48E***P Series, Инструкция по эксплуатации

Страница: 10 / 34

10 P2144BA/EN 2014-08
2144b-en_1_5_bedingt.fm, 09.09.2014
Safety
1
1.3 Operator training

The fastening system and the electric tool may only be connected, adjusted or used by suitably quali-
fied
1)
and trained persons.
 The electric tool must only be repaired by authorized technicians from the Apex Tool Group.
 Ensure correct programming. Only qualified persons are permitted to adjust the controls for the specific
requirements of your threaded connections. Additional information can be found in the Programming
Manual.
1.4 Designated use
The tool is designed exclusively for fastening and releasing threaded fasteners.
 Only use in conjunction with a control and tool cable supplies by Apex Tool Group.
 Do not use as a hammer or for re-bending.
 Do not open it or modify it structurally.
 Do not use it in areas where there is a risk of explosion.
1.5 Standards
1.5.1 EMC
Industrial environment
EMC limit class A.
The tool complies with the following EMC standards:
EN 55011:2007, EN 61000-6-2:2005
1.6 Noise and Vibration
Sound pressure
Lp < 70 dB(A) in free speed (without load) as per DIN EN ISO 4871:1997-03
The vibration values < 2.5 m/s² are in accordance with DIN EN ISO 20643:2005-03
1. Due to their vocational training, knowledge, experience and understanding of the circumstances involved in this kind of work, suit-
ably qualified personnel are able to identify potential hazards and to initiate appropriate safety precautions. Qualified personnel are
obliged to comply with regulations.