ClearWater CD15/O2, Инструкция по установке и обслуживанию

Страница: 30 / 36

29
OZONE GENERATOR TROUBLESHOOTING
PROBLEM/SYMPTOM POSSIBLE CAUSE SOLUTION
Unit does not turn on No power to unit Check breakers
Switch not turned on Check switch
Blown fuse Replace fuse on bottom of unit
Cover/door interlock not active Check door interlock switch
replace cover
Incorrect wiring connections Check wiring (see manual)
Unit does not stay on Insufficient vacuum Adjust injector vacuum, check pump, be
(should be -5 to -15 on SCFH gauge) sure check valves are properly installed
Defective solenoid Inspect and repair/replace if necessary
Defective check valve Inspect and replace if necessary
Unit overheating Clean fan filter, check fan
Unit cycles on and off Overheating Clean fan filter, check fan
Defective power Check for constant power if not
timer controlled
Defective solenoid Inspect and repair/replace if necessary
Individual drive indicator No power to drive module Check drive module (see illustration)
lights not on
Blown fuse or lamp Replace fuse or lamp
Drive module burnt out Replace drive module
Unit trips circuit breaker Incorrect wiring Check wiring (see manual)
Incorrect circuit breaker Check and, if necessary, replace with
correct circuit breaker
You receive an electrical shock Incorrect wiring Check wiring (see manual)
upon touching the unit
Unit not grounded Ground unit in accordance with local
codes
Unit has been flooded Return unit for major service or
completely disassemble and clean
Water in unit or Insufficient vacuum Adjust injector vacuum
ozone delivery tubing
Defective check valve(s) Replace check valve(s)
Excessive back pressure on check valve Back pressure not to exceed 40 psi -
if over 40 psi consult ClearWater Tech
distributor
Ozone smell present Insufficient vacuum Adjust injector vacuum
Loose internal fittings Inspect and tighten fittings
Defective O-ring seals in Check and replace if necessary
reaction chamber
Defective dielectrics Check and replace if necessary
Defective reaction chamber Check and replace if necessary
You suspect that no ozone Drive module failure Touch the bottom of the coil -
is being produced replace if it is not warm
Dielectric failure Inspect and replace if necessary