ClearSpan PB03100R4, Руководство пользователя, Страница: 9 / 27

Rafter Introduction
All rafters consist of the following five (5) pipes: 2 (42R3501D), 2 (42R3501), and 1 (42R3502). The
two 42R3501D pipes include two drilled holes near the bottom to connect the rafter foot.
Assemble Rafter A (There are two (2) end rafters.)
1. Connect the pipes as shown in Diagram A below.
2. Assemble rafter on the ground; slide swaged section into plain section until 9/16” holes line up
(Figure 1). Secure each pipe joint with one ½" x 5½" bolt and a single Purlin Connection Bracket
(Figure 2).
3. Insert one rafter foot (105242) into the bottom of the rafter and secure with (1) one ½" x 5½" bolt
and a single Purlin Connection Bracket in hole furthest from foot base. In hole closest to foot
base, secure foot to rafter using ½" x 4½" bolt (Figure 3).
4. Repeat Step 3 for the remaining rafter foot.
5. Repeat the above steps to assemble a second Rafter A.
ATTENTION: Install all brackets and bolts so they do not interfere with the installation of the main cover. To protect the
cover, tape all rafter joints with duct tape.
Diagram A
Figure 2
Figure 1
Figure 3
42R3501D
42R3501
42R3502
Arrow points
to the inside
of the shelter.
Position purlin bracket to the inside of the shelter.
Duct Tape here
Visit www.ClearSpan.com for additional products and customer assistance. 8 of 26