ClearSpan PB03100R4, Руководство пользователя, Страница: 17 / 27

Main Cover Installation
WARNING: To prevent personal injury and damage to the structure and main cover, do not attempt to install
the main cover on a windy or stormy day.
Assemble Cover Conduits
Cover conduits are pipe assemblies that are slid into pockets sewn into the bottom edge of the main cover.
These conduit assemblies consist of the following pipes:
1.66" Cover Conduit (Quantity 2):
99" (166S099) Swaged pipe
XX" (166P0xx) Plain pipe (Use this pipe last to end the run of pipe.)
The X's represent the length needed to reach the end of the cover. Locate the cover conduit pipes and
assemble them. The conduits can be assembled at once or in short sections. Secure each joint with a Tek
screw and use duct tape to tape the joint and screw to protect the cover.
Install the Main Cover
1. Unpack the main cover and unfold it with the inside surface facing up. (The pockets for the cover conduits
should be visible when the cover is unfolded.) See the example below.
2. Locate the ends of the main cover with the strapping and align the ends with the front and back of the
frame assembly.
Frame shown is to illustrate the location of the cover during installation.
3. Slide one of the 1.66" cover conduits into the hem opening and repeat this step using the other 1.66" cover
conduit and the remaining hem opening. Remember to secure the conduit joints with a Tek screw and to
tape the joint with duct tape.
4. Grasp each end of the cover conduit and carry the main cover toward the frame assembly and place on the
ground along the frame side.
ATTENTION: Do not use the black straps in the main cover to pull the cover into position. They will pull out
of the cover hem and must be rethreaded to properly secure the cover.
Cover Conduit
Pull cover from this
end toward the frame.
Visit www.ClearSpan.com for additional products and customer assistance. 16 of 26