ClearSpan PB03100R4, Руководство пользователя, Страница: 19 / 27

10. Select one of the 5' tie down straps that shipped with the building and insert one end of the strap through
the sleeve opening, around the cover conduit, and back through the opening.
11. Feed both ends of the strap through the slot in the ratchet and tighten slightly.
NOTE: Do not fully tighten the strap at this time.
12. Repeat Steps 10 and 11 for the remaining straps.
13. After all side security straps are in place and slightly tightened and the cover is centered evenly on the
frame, complete the following steps to install the PVC cover conduit as described in the following
procedure.
Installing the Main Cover PVC Conduit
To better secure the main cover on longer buildings, PVC conduits are used near the ends of the cover to
provide an additional tie-down position. Complete these steps to assemble and install the PVC conduits.
1. With the main cover in position on the frame and the end straps loose in the ratchets, locate the pocket for
the PVC conduit near the end of the main cover and insert one length of the PVC pipe (smooth end first).
2. Select another piece of PVC, feed it into the pocket of the main cover and into the bell end of the first piece
of PVC. Use duct tape (or PVC glue–not provided) to secure each PVC joint.
Photo shows a different
shelter with a similar
ratchet and cover
design. The procedures
to secure the main
cover are identical
despite the differences
in the frame assembly.
Visit www.ClearSpan.com for additional products and customer assistance. 18 of 26