CLEARSPAN
™
GARAGES & STORAGE SHEDS
13
Revision date: 06.11.08
ANCHOR THE SHELTER
At this point, anchor the shelter. Consult the MUST READ
document for anchoring information and suggestions.
Please call customer service at 1-800-245-9881 for
additional anchoring information.
CAUTION
: The anchor assembly is an integral part of
the shelter construction. Improper anchoring may
cause shelter instability and failure of the structure
to perform as designed. Failing to anchor the shelter
properly will void the manufacturer’s warranty and may
cause serious injury and damage.
ATTACH END CONDUIT ASSEMBLIES
1. Verify the end conduits of end panels are inserted into
the T-fittings correctly.
End Rafter
T-fitting
Allen
Screw
End Panel
Purlin
End Conduit
ATTENTION:
Do not allow the end conduit to extend
into the opening that remains for the bottom of the end
rafters.
2. Insert the bottom of the end rafters into the T-fitting of
the end conduit.
3. Verify that the rafter pipe is flush with the bottom of the
T-fitting.
4. Tighten the Allen screws to secure the T-fitting to the
end rafter and end conduit.
CORRECT
INCORRECT
ATTACH END PANEL ASSEMBLIES
Gather the Parts:
• End Panel Assemblies
• Fabric Clips (Divide clips equally for both end panels;
save four to six (4-6) clips for roll-up crank assembly.)
• Tek Screws
• Measuring Tape
• Scissors
Assembly Procedure:
1. While standing inside the shelter, start at the peak of
the end rafter and pull the solid (plain) end panel over
the top of the rafter so the material edge is on the
inside of the rafter.
2. Secure the solid end panel in place at the top center of
end rafter with a fabric clip and Tek screw.
3. Moving outward in both directions, place fabric clips
spaced evenly on rafter.
4. Secure each fabric clip to end rafter with a Tek screw
(on side where it will not contact cover).
NOTE:
The end panels may be shipped as untrimmed
rectangular pieces. If so, use scissors to trim the
excess end panel material inside the shelter to an inch
or two past the fabric clip as shown below.
5. Secure the zippered end panel in place using fabric
clips and Tek screws as completed on the plain end
panel.
