ClearSpan PB00400R4, Руководство пользователя

Страница: 12 / 25

CLEARSPAN
™
GARAGES & STORAGE SHEDS
12 Revision date: 06.11.08
PREPARE END PANELS
CAUTION: To prevent damage, do not install end
panels on a windy day.
Gather the Parts:
• End Panel Solid (Plain)
• End Panel 2-Zip (Zippered)
• End Conduit Assemblies (2)
• Scissors
Assembly Procedure:
1. If the corners of the end panels have not been cut out,
follow this procedure:
2. Remove one T-fitting from the end conduit assembly
and slide the end conduit assembly into the hem at
the bottom of the solid (plain) end panel. Replace the
T-fitting that was removed.
3. On the zippered end panel, insert the end conduit
through the two side panels of the end panel (as shown
below) and not through the door section.
a. Lay an end panel out on a clean flat surface.
b. Place the end conduit assembly centered side-to-
side on top of the hem.
c. With scissors, trim the corner of the end panel
on the dotted line shown below so the T-fitting is
exposed when conduit is placed inside the hem.
d. Repeat the same steps for the other end of this
end panel and for both ends of the remaining end
panel.
End Conduit
through Side
Panel
End Conduit
through Side
Panel
END CONDUITS ASSEMBLY
Gather the Parts:
• Pipe 1.315'' x 75'' Swaged (4).
• Pipe 1.315'' x 25.5'' Plain (2). Trim to fit.
• T-fittings
• Duct tape (supplied by customer)
• Metal Cutting Saw
• Tek Screws
Assembly Procedure:
1. Locate the end conduit pipes and T-fittings. Each end
conduit consists of two (2) 75” pipes, one (1) 25.5”
pipe, and two (2) T-fittings. Two (2) end conduits are
required.
NOTE: To maintain the 14' on-center width of the
frame, cut the 25.5" pipe to 23".
2. Assemble an end conduit by connecting two (2) 75''
swaged pipes to the 23'' plain pipe and secure the joint
using a Tek screw. Tape over the Tek screw to protect
the end panel.
3. Repeat assembly for the remaining end conduit.
4. Add the T-fittings at the ends of the conduits and
tighten the Allen screws.
NOTE: Do not insert the end conduit pipes all the way
into the T-fittings, but instead allow room for the end
rafter to be inserted later.