CLEARSPAN
™
JUBILEE TENTS
12
Revision date: 07.01.08
PREPARE MAIN COVER
Gather the parts:
Cover
•
Rope (included)
•
Ropes long enough to reach over the frame (provided
•
by customer)
May not be needed for some shelters.
The side flaps of the cover will hang over the base rafters
and are attached to the lower base rafters with rope.
WARNING:
To prevent damage to the cover and to
prevent serious personal injury, DO NOT attempt to
install the main cover on a windy day.
ATTACH MAIN COVER
NOTE:
Assistance will be required for cover installation.
Unfold cover and lay out along one side of frame.
1.
Using the grommets (eye-holes) under the side flap, tie
2.
rope to the corners of one side of the cover. The ropes
must be long enough to reach over the frame to the
other side. Ropes are not used for smaller shelters.
Toss the ropes over the frame and carefully pull the
3.
cover up onto the frame, making sure the cover does
not snag.
Once the main cover is pulled into position, center the
4.
cover on the frame. Temporarily secure the cover to
the frame using a few short sections of rope.
Beginning at a corner, thread the end of rope through
5.
a grommet and around the lower base rafter. Use the
lacing pattern shown below as a guide.
Pull rope to remove excess slack and tie off.
6.
Repeat Steps 5 and 6 for the remaining three sides.
7.
NOTE
: To keep cover centered, install all ropes before
the cover is fully tightened.
Return to each rope section and tighten.
8.
Once the main cover is tied down, secure the side
9.
flaps at each corner. Slide rope through a grommet,
around rafter, back through the other grommet, and tie
together.
Rope
Continue by reading the Install Optional Panels section.
10.
If you do not have side panels to install, continue by
reading the Shelter Care and Maintenance information.
Work toward corner
