User manual / Bedienungsanleitung
Page / Seite 6
© clearaudio electronic GmbH, 2022-01
2. Installation on Clearaudio turntables
2.1. Installation on a Solution base
For the installation please remove the tonearm and the base from your turntable.
Fit the
VTA-Lifter
(2) from above through the hole of the base.
Pic. 3: Tighten the
VTA-Lifter in a Solution
base
Pic. 2: Mounting the
VTA-Lifter in a Solution base
Please mount the
VTA-Lifter
(2) with the lever rearwards (see pic 2).
Tighten the
VTA-Lifter
(2) with the delivered cylinder head bolts and the hex key wrench (3 x 8) on
the bottom side of the Solution – base (see pic. 3).
Now you can mount the Solution base on the turntable chassis again.
2.2. Tonearm set up (only for Clearaudio Radial tonearms)
To install a Clearaudio radial tonearm (e.g. Unify, Satisfy and Universal) please pull the cable
carefully trough the hole of the
VTA-Lifter
(2).
After you have set up the tonearm into the hole please make sure that the tonearm is exactly on the
line between “+” and “-“(top view) (see pic. 3) on the
VTA-Lifter
(2).
Pic. 3: Installation of the
VTA Lifter
Bottom side of the Solution base
