User manual / Bedienungsanleitung
Page / Seite 8
© clearaudio electronic GmbH, 2022-01
2.5 Installation on other turntables
To install the
VTA-Lifter
on the turntable chassis, you will need to drill the required holes.
Please refer to the drilling template shown below (Picture 8) for the measurements to mark the
exact drilling holes.
Please be informed, that this drawing is not suitable for use as a mounting tool.
Use a 3.2mm HSS drill bit.
Please note:
This drilling template is only for 9 inch tonearms. You will find the the correct pivot to
spindle in the user manual of the tonearm.
Pic. 8: Mounting the
VTA-Lifter on a non-Clearaudio turntable
