User manual / Bedienungsanleitung
Made in Germany
Page / Seite 13
5.4 Adjustment of the azimuth
The azimuth is the angle of the cartridge stylus to the record surface. Viewed from the front, the
cartridge needle have to be vertical to the record.
Please note: The azimuth is already set at the factory.
If you still want to optimize the azimuth, lower the cartridge onto the record surface and check the
position of the needle.
To change the azimuth, please proceed as following:
Loosen the screw (hex wrench #2) on the bottom side of the tonearm tube near the headshell.
Now you can adjust the azimuth by turning the headshell in the tonearm tube.
After you have found the correct position, carefully tighten the small hex screw again without
changing the previously selected position.
To check the adjustment, we recommend the “Mini Level Gauge” from Clearaudio
(Art.No.: AK001;
also available from www.analogshop.de)
Pic. 14:
Azimuth adjustment
Pic. 15: Screw to adjust the headshell
