Cleanmaxx PC-C001-1, Инструкция по эксплуатации

Страница: 21 / 48

21 EN
1. Pull out the length of mains cord that you need. Do not forcefully pull the cord out
up to the stop. Do not pull it out any further than to the red mark. The yellow mark
indicates the ideal cord length.
2. Connect the mains plug to a properly installed socket.
3. Press the On/Off switch to turn the vacuum cleaner on.
4. Move the nozzle over the surface you want to clean.
5. After vacuum cleaning, press the On/Off switch to turn off the vacuum cleaner.
6. Remove the power plug from the socket. Firmly hold the mains cord and push the
button to recoil the mains cord. By holding the cord, you prevent it from “whiplashing”
against body parts such as your legs.
Cleaning
ATTENTION!
• Always pull the mains plug out of the socket before cleaning the fi lters and emptying
the dust bin.
• Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the
vacuum cleaner housing. They could damage the surface.
Emptying the dust bin
1. Depress the release button and at the same time, pull the dust bin out from above.
2. Hold the dust bin over an open garbage bin.
3. Push down on the dust bin fastener. The container lid will open and you can empty
the container.
4. Close the lid of the dust bin. The fastener must lock into place. Help closing the lid if
necessary by pushing the fastener up against the dust bin lid.
5. Depress and hold the release button and put the dust bin
back in the vacuum cleaner. The dust bin has been prop-
erly positioned when the release button pin (
C ) is located
under the bracket ( D ) on the vacuum cleaner housing (see
fi gure).
Cleaning the motor fi lter
1. Remove the dust bin (see section “Emptying the dust bin”).
The motor fi lter ( 1 ) is located behind the dust bin in the
vacuum cleaner housing. It is protected by a foam fi lter.
2. Remove the foam fi lter.
D C
1
07420_DE-EN_FR-NL_A5_V1.indb 21 07420_DE-EN_FR-NL_A5_V1.indb 21 15.07.2015 09:19:11 15.07.2015 09:19:11