EN 18
Cleaning the Dust Container and HEPA Filter
1. Press onto the dust container (
4
) to unlock it.
2. Reach into the recess in the dust container and pull it up and out of the motor unit (
3
).
3. Reach into the opening and pull the HEPA-
fi
lter out of the dust container.
4. Empty the dust container.
5. Wipe out the dust container with a dry duster if necessary.
6. Tap out the HEPA-
fi
lter and clean it with a soft brush if necessary.
Please
note: For
thorough cleaning the
fi
lter can be rinsed under cold (!) running water.
NOTICE:
Allow the HEPA-
fi
lter to dry completely before the device is reassembled.
7. Insert the HEPA-
fi
lter into the dust container.
8. Insert the dust container into the motor unit. It must audibly click into place.
Cleaning the UV-C Lamp
PLEASE NOTE!
■
CAUTION – Danger of Burns!
The UV-C lamp will become hot during use. Allow the
UV-C lamp to cool suf
fi
ciently after using the device.
1. Undo the two screws on the cover (
8
) of the UV-C lamp (
11
) and take off the cover.
2. Wipe down the UV-C lamp with a dry duster.
NOTE:
Make sure that you do not touch
the UV-C lamp with your
fi
ngers!
3. Place the cover back on and
fi
x it in place with the two screws.
Troubleshooting
If the device does not work properly,
fi
rst check whether you are able to rectify the prob-
lem yourself. If the problem cannot be solved with the steps that are listed, contact the
customer service department.
Do not attempt to repair a electrical device yourself!
Problem
Possible cause / solution / tips
The device
generates no
suction.
• Is the mains plug inserted in the socket correctly? Correct the
fi
t of the mains plug.
• Is the plug socket defective? Try another socket.
• Check the fuse of the mains connection.
• Is the device switched on? Press the On / Off switch (
1
).
Low suction
force.
• Is the dust container (
4
) too full? Empty the dust container.
• Is
the
fi
lter heavily clogged up? Clean the
fi
lter.
• Is the suction opening (
7
) blocked? Switch off the device, pull
the mains plug out of the plug socket and remove the blockage.
