HOW TO BLEED
WITHOUT ELECTRIC INSTANT WATER HEATER:
1. Fill solution tank with clean water.
2. Connect desired tool and extractor with vacuum hose and solution hose.
3. Turn pump switch to “ON”.
4. Open trigger valve from your attachment tool (See image 15.1), and spray until all air is out from the solution
system. (See image 15.2) It might take 2-4 minutes depending on the jet size from the attachment tool.
13
WITH ELECTRIC INSTANT WATER HEATER:
WARNING: DO NOT TURN ON THE HEATER until you have following steps.
1. Fill solution tank with clean water.
2. Connect desired tool and extractor with vacuum hose and solution hose.
3. Turn pump switch to “ON”.
4. Open trigger valve from your attachment tool (See image 15.1), and spray until all air is out from the solution
system. (See image 15.2) It might take 2-4 minutes depending on the jet size from the attachment tool.
5. Turn heater switch on and wait approximatley 3-4 minutes to heat up. Now you are ready to use your extractor
with IN-LINE heater.
DID YOU KNOW?
The quickest way to bleed air out is taking all the jets out and then following steps 1 through 4 before replacing
the jets.
Press the lever to open the valve
TMI
MADE IN U.S.A.
Once the line is
clear of air you
wil begin to see
water
HOW TO
image 15.1
image 15.2